Hytec Electronics Ltd
Data
Acquisition and Control
6335 PCI Express IP Carrier Board
The 6335 is an Industry Pack Carrier
card for the high performance PCI Express serial bus. This card
is used in a ‘X1’ PCI Express slot and can accommodate two Industry
Packs, which can be clocked at either 8MHz or 32MHz (individually selected). The
PCI Express bus is converted to a ‘local bus’ by a bridge chip and then
this local bus is interfaced to the Industry Pack (IP) Logic connectors
by a Xilinx chip.
The
IP interface supports Memory, I/O, ID and Interrupt access to the
Industry Packs in the same way as is used in the 9010 IOC from Hytec.
IP interrupts are mapped to the PCI Express bus. Driver support is
available for both Windows and LINUX environments.
I/O
connections are via SCSI-2 connectors mounted either on the carrier PCB
or on a short cable. This short cable can be terminated either on an
adjacent slot bracket or simply exit from the case through a slot in the card’s bracket. These I/O
connections are compatible with Hytec’s range of DIN-rail mounted I/O
termination and breakout assemblies.
| HYTEC Head Office Post : 5 Cradock Road, Reading, Berkshire, RG2 0JT, England. Phone : +44 (0)118 9757770 Fax : +44 (0)118 9757566 |
Copyright © 2009 [Hytec Electronics Ltd]. All
rights reserved.
Information in this document is subject to change
without notice.
Other products and companies referred to herein are
trademarks or registered trademarks of their respective companies or
mark holders.
Our policy is one of continuous product development
and the right is reserved to supply equipment which may vary slightly
from that described.